[. . . ] When depressed the display gives off an audible signal and the background light comes on. If the screen is not touched for 30 seconds it automatically returns to the normal display. Important: On the wind direction sensor's edge are the letters N, E, S and W which stand for the four directions (north, east, south, and west). The wind direction sensor's placement must be adjusted so that the direction corresponds to actuality, otherwise the readings will not be accurate. [. . . ] Touch the same section again in order to set the alarm to sound for high humidity. Press the same section for a third time in order to display the highest measured humidity. Select the average wind speed or highest measured wind speed by pressing the "+" or "­" buttons. Touch the same section a third time in order to set the alarm to sound for high wind speeds. Change the values with the "+" and "­" buttons or turn off the alarm with the ON/OFF button. Touch the same section a fourth time in order to set the alarm to sound for wind direction. Wind direction flashes in the display Use the "+" and "­" buttons to set the alarm to sound for the wind direction of your choosing. Use "+" or "­" to select the displaying of the amount of rainfall every hour, 4 hours, week, month or total overall rainfall. Press the rain gauge again and then "+" or "­" to display rainfall amounts in mm or inches. Touch the same section a third time in order to set the alarm to sound for high rainfall amounts. Change the values with the "+" and "­" buttons or turn off the alarm with the ON/OFF button. In order to reset the rain gauge, press the section and hold for 3 seconds. The rain gauge settings for hour, 4 hours, week, month, and total rainfall amounts are reset. Shift the display between sunny, cloudy, overcast and rainy with the "+" and "­" buttons. Use "+" and "­" in order to choose the threshold value for barometric pressure from ­ 4 hPa ( hPa is the pre-programmed value). Touch the same section a third time and use "+" and "­" to set the threshold value for storm from 3 - 9 hPa (4 hPa is the pre-programmed value). Press the section for barometric pressure and use "+" and "­" to choose absolute barometric pressure (the actual barometric pressure regardless of altitude) or relative barometric pressure (calculated from a combination of values for absolute barometric pressure and altitude). Use the "+" and "­" buttons to change between the the values for hPa, inHg and mmHg. Press the same section for a third time in order to adjust the settings for relative barometric pressure. Touch the same section a fourth time in order to set the alarm to sound high barometric pressure. Change the values with the "+" and "­"buttons or turn off the alarm with the ON/OFF button. Press the section for a fifth time and set the alarm to sound for low barometric pressure in the same way as the alarm was set for high barometric pressure. [. . . ] When the weather station is connected to the computer the is disconnected the icon is shown instead. This section is used to set up PC software display, base station units, as well as able or disable the corresponding alarm function. Make desired settings and push Save to save the settings or Cancel to cancel without saving. Clear Memory: Erases all saved weather data in the weather station's memory Shows a graph over saved weather data Export: Cancel: Exports weather data to an external program Cancel and close the window If you want to save the archived data you can copy the file EASYWEATHER. [. . . ]